Installation Steps for Canopy Tents

Aug 12, 2026 Leave a message

Instant Folding Canopy (for market stalls or temporary outdoor use)
‌Frame Setup & Canopy Placement: Remove the frame and canopy fabric; open the frame halfway (50%), align the fabric with the top of the frame, and secure the four corners using the Velcro straps.
‌Full Frame Expansion: Pull the frame open to 95% capacity; engage the spring-loaded locking pins on each leg into the corresponding holes on the sliding square tubes (perform this simultaneously on all four corners).
‌Height Locking: Pull the four inner legs (with base plates) upward; they will lock automatically upon reaching the preset height, completing the installation.

 

Wall-Mounted Canopy (for long-term balcony or terrace use)
‌Measurement & Positioning: Use a tape measure and spirit level to mark the mounting holes, ensuring the height is perfectly level on both sides; measure for a width 10cm greater than the actual requirement to avoid fitment issues.
‌Bracket Installation: Drill holes at the marked locations using a hammer drill, insert expansion bolts, mount the wall brackets and main framework, and tighten the nuts-ensuring the brackets are perfectly vertical and stable.
‌Canopy Assembly: Hang the main canopy unit onto the brackets, adjust the tilt angle (a 60°–70° angle relative to the ground is recommended), install side supports and gutters, and leave gaps between panels to allow for thermal expansion.
‌Sealing & Testing: Apply weather-resistant sealant to joints and install sealing strips to prevent leaks; repeatedly test the extension and retraction mechanism for smooth operation, check all screws for tightness, and clear away any debris from the site.